Description
F40 Fuel Vapor / Charcoal Canister Sticker 143813
222 | F40 Fuel Vapor / Charcoal Canister Sticker 143813
$25.00
Related products
-
13 | 365 Daytona air cleaner sticker
$30.00With the introduction of the Daytona series Ferrari began using a large foil service sticker on the top of the air cleaner. This sticker is 70x120mm, has “Warning” on the sides and lists the service intervals for the emission control components. It is mounted on the top of the air cleaner, in the front, turned so that it can be read from the rear of the engine. A lot of these types of details can be seen on the Daytona registry web site www.daytonaregistry.com. Daytona Air Cleaner Service Sticker
Add to cart -
28C | Voltage regulator decal 1R50A
$20.00These are reproductions of three different voltage regulators from the late 1950s through the early 1960s. The decals are mounted so that the top of the writing faces the bottom of the mounting surface as the regulator is attached to the electrical panel. The voltage regulator information is not contained on the build sheets and the changes were probably made by Pininfarina to adjust the electrical system to the additional electrical equipment of the later cars. Voltage Regulator Decal 1R50A, Lusso #4391 and late GTEs
Add to cart -
16 | Oval foil coil stickers
$15.00In 1959 Ferrari began production of the new 250 series “outside plug” engines. These engines had the spark plugs moved from the center of the engines to the lower side of the heads near the exhaust ports. At about the same time Magneti Marelli supplied a new series of red coils. These coils were in two configurations. The earlier version used a small tubular-shaped resister that resembled the American “Tootsie Roll” candy, hence the nickname “Tootsie Roll” coils. These were used as late as the early 250 GTEs. The can, bracket and the resister were painted red. The second series used a square-shaped ceramic resister. These coils were painted red along with the ceramic resisters. I believe that both the cans and the square resisters were painted the same color; however, over time the resister color might change a bit due to heat build-up. The coils with the square resisters had a separate mounting bracket with the bracket, pinch bolt and nut, and mounting screws plated with silver or white cadmium. The square resisters had the ohm rating silk-screened on the top surface. Both of these coils used a truncated oval Magneti Marelli foil sticker located 1/4″ from the bottom of the can on the “front” surface centered in line with the resister. The changes in pieces like these, which were supplied by outside vendors, normally did not coincide exactly with Ferrari model or yearly changes. The records of the timing of these changes are sketchy at best so teh restorers and judges are always looking for original components and photos to try to document the timing of the changes. Oval Foil Magneti Marelli Coil Stickers.
Add to cart -
35 | Distributor cap numbers
$15.00These numbers are used to denote the firing order sequence and are positioned in the top of the distributor caps. This package is for the numbers 1-6, for each distributor and a spare set in case of a mistake. Distributor Cap Numbers.
Add to cart