$15.00
The right angle drives used to mount the Marelli Distributors have deep webbing around the fasteners used to attach them to the block and heads. Ferrari used bolts with a 4mm shoulder and extra thick nuts so that a wrench could reach them between the webbing. These bolts and nuts are often lost during a restoration project. Extra Deep Distributor Drive Nuts, 8 nuts for 2 distributors
The 250’s and earlier cars used the tubular screw type jacks made by three or more manufacturers. The small tubes in the lower valence panels of the cars were a weak point and these jacks should be kept in the old tool bags and not used as they are likely to damage the cars. These are the chrome-plated plugs for the jack holes on the side of the cars. Jack Hole Plugs…4 per car.
Read more
On the 250 series P.F. cars, such as the Coupes, Cabriolets and the GTEs, the electrical panels are mounted in the engine compartment and are protected from the elements by a black wrinkle-finished aluminum panel. These covers are held in place with three small knobs. These knobs are machined from brass bar stock and nicely finished in chrome. 250 P.F. Electrical Panel Knobs.
Original Ferrari Part Number: 239-80-348-02
***Note: These cover nuts are sold individually.
Add to cart
Most of the 250 and later cars used a small slotted jam nut to secure the gear shift knob. These are beautiful reproductions in brass with a chrome-plated finish. Gear Shift Knob Jam Nuts
Add to cart
Scaglietti Hinge Pin With Original Two Piece Grease Button Cap
Add to cart
