$35.00
This type of nuts were used on all of the outside-plug 250s from the time of the introduction of the GTEs through the last of the 250 Lussos. The 275 series cars changed to the flat, round, knurled nuts. Three-ear air cleaner nuts.
(Sold Individually)
Product Search: Kil-10
Metal tie wraps were used to gather hoses, wiring and control cables to minimize the mess in the engine compartment. They were typically seen on the heater hoses, Venetian blind cables and other places in the engine compartment. Usually there would be three or four per car. Aluminum Tie Wraps, Aluminum type were used for the early cars until about 1959.
Product Search: Kil-42-1
Add to cart
The 250’s and earlier cars used the tubular screw type jacks made by three or more manufacturers. The small tubes in the lower valence panels of the cars were a weak point and these jacks should be kept in the old tool bags and not used as they are likely to damage the cars. These are the chrome-plated plugs for the jack holes on the side of the cars. Jack Hole Plugs…4 per car.
(Sold as a set of 4)
Product Search: KIL-102
Read more
The right angle drives used to mount the Marelli Distributors have deep webbing around the fasteners used to attach them to the block and heads. Ferrari used bolts with a 4mm shoulder and extra thick nuts so that a wrench could reach them between the webbing. These bolts and nuts are often lost during a restoration project. Extra Deep Distributor Drive Nuts, 8 nuts for 2 distributors
Product Search: Kil-40-1
Add to cart
The firewall hole is two circles with the circumferences connected by tangent lines, 88mmx50mm. The shaft is 35mm. Daytona Steering Shaft Grommet
(Sold Individually)
Product Search: KIL-125
Add to cart
