$50.00
There were at least three different cardboard wrappers used by Pirelli during the time that they supplied the fan belts to Ferrari. This is a new reproduction of the most commonly seen Pirelli Fan belt boxes. Pirelli Fan Belt Box.
(Sold Individually)
Product Search: KIL-116
The very early Ferraris had the exhaust system mounted solidly to the chassis. They later changed to a type of hanger with metal ends and flexible center section made of belting or truck tire sidewalls. The early ones were what are called the “Center-pull” design. In this configuration the four steel components are all the same design. These end pieces are all bent so that the force goes through the center of the assembly. This design was originally painted black until the mid 1950s when a change was made toa cadmium finish. Later, about 1962 during the run of the 250 GTEs the hanger design was changed to the more common “Side-Pull” arrangement. Cadmium – Plated Center – Pull Exhaust Hangers
(Sold Individually)
Product Search: KIL-121B
Add to cart
I looked and looked for correct Pirelli fan belts for my old 250 Cabriolet with no luck. Finally I made a silk screen jig and began silk screening modern belts with the correct old – style Pirelli information. My silk screen and jig can only do the long belts for the outside plug engines that had generators, and the very short belts that were used on the front mounted generators on inside plug 250 engines. Short Fan Belt for 250 Inside Plug Engines
(Sold Individually)
Product Search: KIL-115A
Add to cart
These round hood bumpers were used on the 250 Scaglietti-built. These truncated cone shpaed hood bumpers were used on the 250 series cars with Scaglietti built bodies. The bottoms of the bumpers are cut so that there is a 1/16″ “press fit” between the bumper and the hood or the trunk when they are closed. These were attached using a trim washer and a slotted flat head sheet metal screw. The P.F. cars used a different piece. Scaglietti Hood Bumpers.
(Sold Individually)
Product Search: KIL-117
Add to cart
For the long distance races or others when there would be a chance for rain Ferrari would use rubber boots to cover the distributors to keep the rain water out of the electrics. There are good photos of the T.R.s using these boots at Le Mans. Large Distributor Boots for the T.R.s
(Sold Individually)
Product Search: KIL-120B
Add to cart
